Dynamic Balancing Machines
The DB1 and DB2 range are single plane, static balancing machines. The DB3 and DB4 are two plane, dynamic balancing machines. The Single plane machines are often used for balancing relatively flat objects such as grinding wheels, cutter blocks, impeller, diamond polishing plates etc. The Dynamic machines can be used to balance any rotating component, the DB3 having a maximum component weight of 20 Kgs, and the DB4 of approximately 45 Kgs.
All machines are extremely simple to operate. After calibration the imbalance position, is indicated within approximately 5 seconds of starting the machine.
The exact weight needed for balance can be displayed to a resolution of 1 milligram. The output can also be in ounces. Software provided allows the machines to be connected to a PC for graphical and numerical indication and to allow balancing parameters and results to be printed for certification purposes. Result can be shown in terms of G, g/mm or pass/fail.
Purpose made mandrels are recommended. Coborn are able to produce mandrels to your exact specification or requirements, including Hydraulic Mandrels for small components.
The DB2 range includes thre machines that allow versatility, the basic DB2 has static pillars, the DB2+ has movable pillars allowing various mandrels to be used, and the DB2B has two pick up sensors which are independant, so the component can be balanced on the left or right of the moveable pillars. The DB2B can be changed into a DB3 on-site without mechanical modification, by exchanging the Amplifier, if move complicated components requiring dynamic balancing are undertaken. Please see the Product Information Page for more details about the entire range.
|- Machine type||Single plane dynamic balancer||Single plane dynamic balancer|
(w x d x h)
|600mm x 340mm
|590mm x 700mm
|- Total machine weight||85kg||120kg|
|- Mandrel||1 off included
- design as requested
|1 off included
- design as requested
|- Maximum diameter||220mm||380mm|
|- Maximum weight||20kg||20kg|
|ACCURACY & RESOLUTION|
|- Auto-ranging facility||Yes||Yes|
|- Software for output to PC||Included||Included|
|- Electrical requirements||3 phase, 415v or 220v||3 phase, 415v or 220v|
|MANDRELS (balancing shafts)|
|1. Hydraulic mandrel||Available - capacity 25mm|
|2. ISO taper mandrel||Available|
|3. HSK mandrel||Available|